The For..to/downto..do statement

13.2.4 The For..to/downto..do statement

Free Pascal supports the For loop construction. A for loop is used in case one wants to calculate something a fixed number of times. The prototype syntax is as follows:

_________________________________________________________________________________________________________
For statement

-- - - - - ----- -----
for statement for control variable := initial value - to --|
----final value-do -statement------------------------downto-----------

--control variable-variable identifier-----------------------------------

--initial value expression -------------------------------------------

-- - --------------------------------------------
final value expression
___________________________________________________________________

Here, Statement can be a compound statement. When the For statement is encountered, the control variable is initialized with the initial value, and is compared with the final value. What happens next depends on whether to or downto is used:

In the case To is used, if the initial value is larger than the final value then Statement will never be executed.
In the case DownTo is used, if the initial value is less than the final value then Statement will never be executed.

After this check, the statement after Do is executed. After the execution of the statement, the control variable is increased or decreased with 1, depending on whether To or Downto is used. The control variable must be an ordinal type, no other types can be used as counters in a loop.

Remark

Free Pascal always calculates the upper bound before initializing the counter variable with the initial value.
It is not allowed to change (i. e. assign a value to) the value of a loop variable inside the loop.
The value of the loop variable is undefined after a loop has completed or if a loop is not executed at all. If the loop was terminated prematurely with an exception or a break statement, the loop variable retains the value it had when the loop was exited.
For nested procedures, a loop variable must be a local variable. If you declare a loop variable outside the nested procedure where the loop is, the compiler will complain. It is however allowed to use a global variable in a procedure.

The following are valid loops:

For Day := Monday to Friday do Work;
For I := 100 downto 1 do
WriteLn (’Counting down : ’,i);
For I := 1 to 7*dwarfs do KissDwarf(i);

The following will generate an error:

For I:=0 to 100 do
  begin
  DoSomething;
  I:=I*2;
  end;

because the loop variable I cannot be assigned to inside the loop.

The following will also generate an error:

program test;

{$ifdef fpc}
{$mode delphi}
{$h+}
{$endif}

procedure Proc;
var
  i: integer;
  procedure Nested;

  begin
    for i := 1 to 2 do ;
  end;

begin
end;

begin
end.

because the variable I is not defined in Nested.

But the following will compile:

program test;

{$ifdef fpc}
{$mode delphi}
{$h+}
{$endif}

var
i: integer;

procedure Nested;

begin
for i := 1 to 2 do ;
end;

begin
end.

If the statement is a compound statement, then the Break and Continue system routines can be used to jump to the end or just after the end of the For statement. Note that Break and Continue are not reserved words and therefore can be overloaded.

[next] [prev] [prev-tail] [front] [up]